Lunch and Models at the St. Francis Yacht Club

This year, the Hyde Street Pier Model Shipwrights club didn’t have the usual annual BBQ due to schedule conflict among members. We put it off a couple times, and next thing you know, the weather isn’t good for it. So, instead, we decided to have a club sponsored lunch. There were a couple possibilities, but since Paul Reck is an associate member of the St. Francis Yacht Club, we decided it would be a nice location for our club lunch, and so we scheduled the lunch to follow our November meeting.

Lunch at the St. Francis

Continue reading

Gunboat Philedelphia, 1776 – Model Progress Update by Paul Reck

HSPMS member Paul Reck shares some photos showing his progress on his 1776 Lake Champlain gunboat Philadelphia, which he is building from scratch in 1/24 scale, based on plans purchased from the Smithsonian.

Paul Reck showing his progress on the gunboat Philadelphia at the October meeting. Member Dan Canada at left.

The original boat was built on Lake Champlain as part of a small fleet of boats by Benedict Arnold in 1776. The project was a race to hold off British plans to move into the Hudson River valley. The boat was lost in the Battle of Valcour Island later in the year, but the loss of this and the other boats of the fleet was a strategic victory for the Americans, as it held off British plans until the end of the campaign year, when it became too late for the British to carry them out for another year.

Continue reading

Amati Swedish Gunboat Build – Part 6

Member Clare Hess posts his latest update on building (and modifying) Amati’s Swedish Gunboat kit. This is a small, inexpensive kit that is short on instructions. Not ideal for beginners, but a nice kit for experienced ship modelers looking for a simple project.

The Ship Modeler

Following our meeting in October, it was clear it was time to finish up the Swedish Gunboat build. We’re down to three active builders of this model from the five that started, which isn’t too bad. One of our  builders decided to finish his up as a gift for someone, and the other is a beginning ship modeler who is anxious to get to his next project. I’m also ready to have a project actually reach completion.

Rigging and Sails

I shaped the masts and the two lugsail yards some time back. I originally added a ball to the tops of the masts as shown on the kit plans, but replaced them with a thinner pole after looking at the photos of the museum model. The presence of the pole creates a shoulder at the top of the mast, that helps secure the shrouds and stays. While modifying the masts…

View original post 804 more words